How do I put my Voltro into BYPASS mode?

Please follow these steps to put the Voltro into BYPASS mode

  1. Please make your way to the electricity distribution board that your Voltro has been installed.
  2. Open it up and look for your Voltro
  3. Make note of the LED light pattern in the indicator as well as the colour of the status LED
  4. Press the BYPASS button firmly
    • you should head an audible 'click' sound
    • the STATUS LED should turn to red
    • if you didn't hear the 'click' sound, then you might not have pressed the BYPASS button firmly enough. Please try again.

By following these steps, your electricity sub-circuit is now working as if the Voltro isn't present.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us